Winding resistance (T=20°C) 25.2 Ω
Resistance Heater (T=20°C) 26.1 Ω
Temperature on surface ~ 115 °C
Detergent capacity: Rinse aid dosage
135 cm³
Electronic boards: Serial boards (Data set)
762621
Electronic boards: Serial boards (UCB programmed)
762631
Alarms: Refill rinse aid (rinse aid control)
Reed contact
Water softener setting
To change the water softener setting:Push the POWER button on Change to program 2 Hold the START button for 5 seconds until the LED is flashing is shown by flashing LED By pushing the START button you can change the setting Push the POWER button off to save and exit the water softener setting
Detergent capacity: Prewash
10 cm³
Drain pump motor: Power Consumption
30 W
Coil of dispenser: Resistance
1,3 k Ω
Electronic boards: Service boards ()
see spare part list
Program information:
All programs will be locked after start. Changing the program or finishing the program will be possible only after pressing the start button for longer then 1.5 sec. (Break by customer)
A switching off the appliance or unplug the appliance for a while, this will frozen the program step and later on, the program continuos on the same position.
Exception: Switching off the appliance or unplug the appliance during the drying phase, this will lead directly to the end of the program.
Електричні базові дані: напруга
220/ 230 V
Flow meter: Flow rate
208 lmp/l
Drain pump motor: Flow rate
16 l/min
Electronic boards: Serial boards (Basic UCB, not programmed)
4619 727 50951
see on the board itself
Single electric water inlet valve: Resistance
3.76 k Ω
Data Energy Label: Drying Performance
A
Single electric water inlet valve: Voltage
220/ 240 V
Motor pump heater: Spray pump pressure
max. 315 mbar
Regeneration valve: Frequency
50/60 Hz
Water hardness: Water hardness German degrees °dh French degrees °fh English degrees Clarke °e mmol/l Water softener setting is shown by flashing LED (1x-7x) or digital display (1-7)
1 soft 0 - 5 0 - 9 0 - 6,3 0 - 0.9 1 x
1 - 2 soft/ medium 6 - 10 10 - 18 7 - 12.6 1 - 1.8 2 x
2 medium 11 - 15 19 - 27 13.3 - 18.9 1.9 - 2.7 3 x
3 medium/ hard 16 - 21 28 - 37 19.6 - 25.9 2.8 - 3.7 4 x (DEFAULT SETTING)
4 hard 22 - 28 38 - 50 26.6 - 35 3.8 - 5.0 5 x
4 very hard 29 - 35 51 - 63 35.7 - 44.1 5.1 - 6.3 6 x
4 extremely hard 36 - 60 (53) 64 - 107 44.8 - 74.9 6.4 - 10.7 7 x
Alarms: Refill salt (salt control)
Reed contact
Motor pump heater: Power Consumption
2040 W ± 5 %
Water softener: Resin container
700 cm 3
Accessory:
If you need spare parts apart from the spare part list have a look in the Service Bulletin 4812 718 40084.
For higher mounted Dishwashers to prevent the drain off effect - also usable for lower drain pipes and to
prevent the failure F8 use Kit 4812 310 18993.
Water softener: Salt container
2 kg
Regeneration: Volume
300 cm³
Drain pump motor: Voltage
220/ 240 V
Programs Permanent washing system: Succession of programs ()
see program diagram
Flow meter: Switch
Reed contact
Detergent capacity: Dosage steps
1 - 6 ml
Electrical base data: Total power
2.2 kW
Coil of dispenser: Frequency
50/60 Hz
Motor pump heater: Rotations
2800 RPM
Spray arm lower 30 RPM - 40 RPM
Spray arm upper 30 RPM - 40 RPM
Water safety option: Waterstop system
Electronic aqua control
Regeneration: after wash cycles
Depending on the water hardness
Dimensions + Weight: Product dimensions (Weight)
56 kg
Single electric water inlet valve: Inlet pressure
0.3 bar - 10 bar
Volume: Water Volume Level
Regeneration 0.3 l 15 mm
Back rinse 3x 1.0 l 60 mm
Prewash 4.8 l 120 mm
Main wash 4.2 l 118 mm
Intermediate rinse 1 4.2 l 118 mm
Intermediate rinse 2 4.2 l 118 mm
Clear rinse 4.2 l 118 mm
Safety/ overflow 8.5 l 141 mm
Regeneration valve: Resistance
3,13 k Ω
Electronic boards: Serial boards ()
Programmed control board and programing of version , see ,,Board Service" and ,,DATA" on rating plate of inner door:
Data Energy Label: Energy Performance
A
Flow rates/ Inlet volume: Flow meter
208 lmp/l
Drain pump motor: Rotations
3000 RPM
Data Energy Label: Reference program
P5i
Model
WRC IC 5B INCORED MPH
Розміри + Вага: Розміри продукту (ширина)
59,7 cm
Drain pump motor: Resistance
146 Ω
Motor pump heater: Safety thermostat self reset (Temperature of water)
85 °C
Електричні базові дані: частота
50 Hz
Coil of dispenser: Voltage
220/240 V
NTC
20 °C 58,1 kΩ
25 °C 47,1 kΩ
30 °C 38,2 kΩ
40 °C 25,4 kΩ
50 °C 17,2 kΩ
60 °C 11,8 kΩ
70 °C 8,3 kΩ
80 °C 6 kΩ
85 °C 4 kΩ
Regeneration: Salt consumption for regeneration
~ 77 g
Електрична база даних: Запобіжник
10 A
Розміри + Вага: Розміри продукту (Глибина)
59,6 cm
Regeneration valve: Voltage
220/240 V
Detergent capacity: Main wash
40 cm³
Motor pump heater: Voltage
220 V - 230 V
Water softener: Regeneration dosage
300 cm 3
Motor pump heater: Frequency
50 Hz
Motor pump heater: Flow rates/ Inlet volume
65 l/min ± 5 %
Pump height max. 1,1 m
Spray arm lower ~ 33 l/min
Spray arm upper ~ 27 l/min
Shower/Spray arm top ~ 8 l/min