All programs will be locked after start. Changing the program or finishing the program will be possible only after pressing the start button for longer then 1.5 sec. (Break by customer)
A switching off the appliance or unplug the appliance for a while, this will frozen the program step and later on, the program continuos on the same position.
Exception: Switching off the appliance or unplug the appliance during the drying phase, this will lead directly to the end of the program.
Электрические базовые данные: напряжение
220 - 230 V / 50 Hz
Mix valve for Regeneration: Resistance
2.0 kΩ
Flow meter: Flow rate
208 lmp/l
Mix valve for Regeneration: Voltage
220/ 240 V
Heating and Pump housing: Temperature on surface
~ 115 °C
Heating and Pump housing: Voltage
220 - 230 V / 50Hz
Motor Diverter Valve: Signal (2x within ~13 sec.)
5.0 V
Programs: Succession of programs
A16a - A17a - A1a - A2b - A3a - A5g - A15a
Présten atención al diagrama programador
Drain pump motor: Flow rate
16 l/min
Electronic boards: Serial boards (Basic UCB, not programmed)
4619 727 58821
see on the board itself
Single electric water inlet valve: Resistance
3.76 k Ω
Single electric water inlet valve: Voltage
220/ 240 V
Regeneration valve: Frequency
50/ 60 Hz
Alarms: Refill salt (salt control)
Reed contact
Motor: Voltage
220 - 240 V / 50 Hz
Water softener: Resin container
700 cm³
Motor Diverter Valve: Voltage
220/ 240 V
Mix valve for Regeneration: Frequency
50/ 60 Hz
Water softener: Salt container
2 kg
Spray arm: Rotations (Spray arm upper)
28 - 42 RPM
Heating and Pump housing: Safety thermostat self reset (Temperature of water)
85 °C
Motor: Type
VSM
Regeneration: Volume
300 cm³
Drain pump motor: Voltage
220/ 240 V
Flow meter: Switch
Reed contact
Detergent capacity: Dosage steps
1 - 6 ml
Electrical base data: Total power
2.2 kW
Heating and Pump housing: Heating resistances
(T=20°C)
26.1 Ω
Motor: Rotations
2400 - 3200 RPM
Coil of dispenser: Frequency
50/ 60 Hz
Heating and Pump housing: Power Consumption
2040 W ± 5 %
Regeneration: after wash cycles
Depending on the water hardness
Dimensions + Weight: Product dimensions (Weight)
58 kg
Programs:
Alternating washing system
Optical water indicator (OWI): Combination part of
Programmed control board and programing of version , see ,,Board Service" and ,,DATA" on rating plate of inner door:
Motor: Power Consumption
30 - 100 W
Drain pump motor: Rotations
3000 RPM
Model
WRC FS EBL TOP 7 VSM MPH
Размеры + Вес: Размеры продукта (ширина)
59.7 cm
Drain pump motor: Resistance
146 Ω
Coil of dispenser: Voltage
220/ 240 V
Regeneration: Salt consumption for regeneration
~ 77 g
Электрическая база данных: Предохранитель
10 A
Размеры + Вес: Размеры продукта (Глубина)
59.6 cm
Regeneration valve: Voltage
220/ 240 V
Water Level: Measuring the level ()
Para medir el nivel de agua en la cuba, sacar el filtro y con un metro medir desde fondo del colector.
Motor: Pump pressure
0.2 - 0.4 bar
Detergent capacity: Main wash
40 cm³
Water softener: Regeneration dosage
300 cm³
Water Level: Water Volume Level
Regeneration 0.3 l 15 mm
Back rinse 3x 1.0 l 60 mm
Prewash 4.8 l 120 mm
Main wash 4.2 l 118 mm
Intermediate rinse 1 4.2 l 118 mm
Intermediate rinse 2 4.2 l 118 mm
Clear rinse 4.2 l 118 mm
Safety/ overflow 8.5 l 141 mm
Motor: Pump height max.
1.1 m
Single electric water inlet valve: Frequency
50/ 60 Hz
Spray arm: Rotations (Spray arm lower)
25 - 45 RPM
Electronic boards: Serial boards (For programing please use Service Assistance Module (S.A.M.))