Схема узла
Запчасти для посудомоечной машины Ignis ADL 348 B
Характеристики:
Motor pump heater: Fuse | 206 °C |
Motor pump heater: Single Phase Synchronous motor | Winding resistance (T=20°C) 29.9 Ω Resistance Heater (T=20°C) 28.2 Ω Temperature on surface ~ 115 °C |
Detergent capacity: Rinse aid dosage | 135 cm³ |
Electronic boards: Serial boards (Data set) | 550031 |
Electronic boards: Serial boards (UCB programmed) | 550041 |
Water hardness: Water hardness German degrees °dh French degrees °fh English degrees Clarke °e mmol/l Water softener setting is shown by flashing LED (1x-7x) or digital display (1-7) | 1 soft 0 - 5 0 - 9 0 - 6,3 0 - 0.9 1 x 1 - 2 soft/ medium 6 - 10 10 - 18 7 - 12.6 1 - 1.8 2 x 2 medium 11 - 15 19 - 27 13.3 - 18.9 1.9 - 2.7 3 x 3 medium/ hard 16 - 21 28 - 37 19.6 - 25.9 2.8 - 3.7 4 x (DEFAULT SETTING) 4 hard 22 - 28 38 - 50 26.6 - 35 3.8 - 5.0 5 x 4 very hard 29 - 35 51 - 63 35.7 - 44.1 5.1 - 6.3 6 x 4 extremely hard 36 - 60 (53) 64 - 107 44.8 - 74.9 6.4 - 10.7 7 x |
Water softener setting | To change the water softener setting:Push the POWER button on Change to program 2 Hold the START button for 5 seconds until the LED is flashing is shown by flashing LED By pushing the START button you can change the setting Push the POWER button off to save and exit the water softener setting |
Detergent capacity: Prewash | 10 cm³ |
Drain pump motor: Power Consumption | 30 W |
Coil of dispenser: Resistance | 1.3 k Ω |
Program information: | All programs will be locked after start. Changing the program or finishing the program will be possible only after pressing the start button for longer then 1.5 sec. (Break by customer) A switching off the appliance or unplug the appliance for a while, this will frozen the program step and later on, the program continuos on the same position. Exception: Switching off the appliance or unplug the appliance during the drying phase, this will lead directly to the end of the program. |
Электрические базовые данные: напряжение | 230 - 240 V |
Flow meter: Flow rate | 208 lmp/l |
Programs: Succession of programs | see program diagram P1a - P3a - P5b - P7a/b |
Drain pump motor: Flow rate | 16 l/min |
Electronic boards: Serial boards (Basic UCB, not programmed) | see on the boards itself 4619 727 50961 |
Single electric water inlet valve: Resistance | 3.76 k Ω |
Data Energy Label: Drying Performance | B |
Single electric water inlet valve: Voltage | 220/ 240 V |
Motor pump heater: Spray pump pressure | max. 315 mbar |
Regeneration valve: Frequency | 50/ 60 Hz |
Motor pump heater: Power Consumption | 2040 W ± 5 % |
Water softener: Resin container | 700 cm³ |
Accessory: | If you need spare parts apart from the spare part list have a look in the Service Bulletin 4812 718 40084. For higher mounted Dishwashers to prevent the drain off effect - also usable for lower drain pipes and to prevent the failure F8 use Kit 4812 310 18993. |
Water softener: Salt container | 2 kg |
Regeneration: Volume | 300 cm³ |
Drain pump motor: Voltage | 220/ 240 V |
Flow meter: Switch | Reed contact |
Detergent capacity: Dosage steps | 1 - 6 ml |
Electrical base data: Total power | 2.4 kW |
Dimensions + Weight: Wooden door for Full Door appliances (Width) | 592 - 595 mm |
Coil of dispenser: Frequency | 50/ 60 Hz |
Motor pump heater: Rotations | 2800 RPM Spray arm lower 30 RPM - 40 RPM Spray arm upper 30 RPM - 40 RPM |
Regeneration: after wash cycles | Depending on the water hardness |
Dimensions + Weight: Product dimensions (Weight) | 50 kg |
Programs: | Permanent washing system |
Dimensions + Weight: Wooden door for Full Door appliances (Height of plinth) | min. 93 mm |
Single electric water inlet valve: Inlet pressure | 0.3 - 10 bar |
Volume: Water Volume Level | Regeneration 0.3 l 15 mm Back rinse 3x 1.0 l 60 mm Prewash 4.8 l 120 mm Main wash 4.2 l 118 mm Intermediate rinse 1 4.2 l 118 mm Intermediate rinse 2 4.2 l 118 mm Clear rinse 4.2 l 118 mm Safety/ overflow 8.5 l 141 mm |
Dimensions + Weight: Wooden door for Full Door appliances (Max. stick out over lower edge of appliance door) | 92 mm |
Regeneration valve: Resistance | 3.13 kΩ |
Electronic boards: Serial boards () | Programmed control board and programing of version , see ,,Board Service" and ,,DATA" on rating plate of inner door: |
Data Energy Label: Energy Performance | B |
Drain pump motor: Rotations | 3000 RPM |
Data Energy Label: Reference program | P5b |
Model | FD IC 4A INCORED MPH |
Dimensions + Weight: Wooden door for Full Door appliances (Height) | 620 - 718 mm |
Размеры + Вес: Размеры продукта (ширина) | 59.7 cm |
Drain pump motor: Resistance | 146 Ω |
Motor pump heater: Safety thermostat self reset (Temperature of water) | 85 °C |
Электрические базовые данные: частота | 50 Hz |
Coil of dispenser: Voltage | 220/ 240 V |
NTC | 20 °C 58,1 kΩ 25 °C 47,1 kΩ 30 °C 38,2 kΩ 40 °C 25,4 kΩ 50 °C 17,2 kΩ 60 °C 11,8 kΩ 70 °C 8,3 kΩ 80 °C 6 kΩ 85 °C 4 kΩ |
Regeneration: Salt consumption for regeneration | ~ 77 g |
Электрическая база данных: Предохранитель | 13 A |
Размеры + Вес: Размеры продукта (Глубина) | 55.5 cm |
Regeneration valve: Voltage | 220/ 240 V |
Detergent capacity: Main wash | 40 cm³ |
Motor pump heater: Voltage | 230 V - 240 V |
Water softener: Regeneration dosage | 300 cm³ |
Motor pump heater: Frequency | 50 Hz |
Motor pump heater: Flow rates/ Inlet volume | 65 l/min Pump height max. 1.1 m Spray arm lower ~ 33 l/min Spray arm upper ~ 27 l/min Shower/Spray arm top ~ 8 l/min |
Dimensions + Weight: Wooden door for Full Door appliances (Weight) | 2.5 - 6.5 kg |
Single electric water inlet valve: Frequency | 50/ 60 Hz |
Electronic boards: Serial boards (For programing please use Service Assistance Module (S.A.M.)) | 4812 289 98001 plus cable 4812 289 98004 |
Data Energy Label: Cleaning Performance | A |
Dimensions + Weight: Wooden door for Full Door appliances (Thickness) | 16 - 20 mm |
Regeneration: Water hardness | 0 - 60 (53) °dh 0 - 10,7 mmol/l 0 - 107 °fh |
Размеры + Вес: Размеры продукта (Высота) | 82.0 - 87.0cm |
Regeneration: Number of cycles with 2 kg salt | ~ 26 |