Схема узла
Запчасти для посудомоечной машины Bauknecht GSIP 90 POWER PT
Выберите версию/индустриальный код: * От выбранной версии зависит совместимость запчастей
854692322720
Характеристики:
Motor pump heater: Fuse | 206 °C |
Water pressure: Inlet pressure | 0,3 bar - 10 bar |
Electronic boards: Serial boards (DB) | 4619 727 58811 |
Motor pump heater: Single Phase Synchronous motor | Winding resistance (T=20°C) 29,2 Ω Resistance Heater (T=20°C) 28,2 Ω Temperature on surface ~ 115 °C |
Rotations: Drain pump motor | 3000 UPM |
Detergent capacity: Rinse aid dosage | 135 cm 3 |
Dimensions + Weight: Wooden door (Height) | 515 mm - 600 mm |
Electronic boards: Serial boards (Data set) | 765831 |
Flow rates/ Inlet volume: Shower/Spray arm top | ~ 6 l/min - 10 l/min |
Alarms: Refill rinse aid () | Salzanzeige |
Spray pump motor: Voltage | 220/ 240 V |
Detergent capacity: Prewash | 10 cm 3 |
Drain pump motor: Power Consumption | 30 W |
Coil of dispenser: Resistance | 1,3 k Ω |
Flow rates/ Inlet volume: Spray pump | 36 l/min - 50 l/min |
Electronic boards: Service boards () | siehe Ersatzteilliste |
Spray arms, turning rhythm at alternating spray system: Intermediate rinse | Spray arm lower ~ 2 min Spray arm upper ~ 2 min |
Электрические базовые данные: напряжение | 220 V - 230 V |
Rotations: Spray pump motor | 2400 UPM - 32000 UPM |
Motor Diverter Valve: Signal (2x within ~13 sec.) | 5,0 V |
Optical water indicator (OWI): Turbidity sensor | (DON) |
Electronic boards: Serial boards (Basic UCB, not programmed) | 4619 727 58821 siehe Boardaufdruck |
Single electric water inlet valve: Resistance | 3,76 k Ω |
Data Energy Label: Drying Performance | A |
Single electric water inlet valve: Voltage | 220/ 240 V |
Water Volume: Wasser Inhalt Höhe | Regenerieren 0,3 l 15 mm Rückspülen 3x 1,0 l 60 mm Vorspülen 4,8 l 120 mm Hauptspülen 4,2 l 118 mm Zwischenspülen 1 4,2 l 118 mm Zwischenspülen 2 4,2 l 118 mm Klarspülen 4,2 l 118 mm Sicherheitsniveau 8,5 l 141 mm |
Regeneration valve: Frequency | 50/60 Hz |
Motor pump heater: Power Consumption | 2040 W ± 5 % |
Rotations: Spray arm upper | 28 UPM - 42 UPM |
Water hardness: Härtestufe Deutscher Härtegrad °dh Franz. Härtegrad °fh Englischer Härte- grad Clarke °e mmol/l Einstellung Blinkfrequenz LED (1x-7x) bzw. Digitalanzeige (1-7) | 1 weich 0 - 5 0 - 9 0 - 6,3 0 - 0.9 1 x 1 - 2 mittel 6 - 10 10 - 18 7 - 12.6 1 - 1.8 2 x 2 mittel 11 - 15 19 - 27 13.3 - 18.9 1.9 - 2.7 3 x 3 mittelhart 16 - 21 28 - 37 19.6 - 25.9 2.8 - 3.7 4 x (Werkseinstellung) 4 hart 22 - 28 38 - 50 26.6 - 35 3.8 - 5.0 5 x 4 sehr hart 29 - 35 51 - 63 35.7 - 44.1 5.1 - 6.3 6 x 4 äußerst hart 36 - 60 (53) 64 - 107 44.8 - 74.9 6.4 - 10.7 7 x |
Flow rates/ Inlet volume: Pump height max. | 1,1 m |
Flow rates/ Inlet volume: Spray arm lower | ~ 36 l/min - 50 l/min |
Water softener: Resin container | 700 cm 3 |
Motor Diverter Valve: Voltage | 220/ 240 V |
Electronic boards: Serial boards (UB) | 4619 724 86782 |
Flow rates/ Inlet volume: Inlet valve | 4 l/min |
Accessory: | Werden Teile benötigt, die nicht in der Ersatzteilliste aufgeführt sind, siehe Service Bulletin 4812 728 40084. Für Hocheinbau von Geschirrspülern um den Saugeffekt zu vermeiden - einsetzbar auch bei tie?iegenden Ab?üssen und zur Vermeidung der Fehlermeldung F8 - Kit 4812 310 18993. |
Water softener: Salt container | 2 kg |
Dimensions + Weight: Wooden door (Max. stick out over lower edge of appliance door) | 92 mm |
Electronic boards: Serial boards (CB programmed) | 765841 |
Regeneration: Volume | 300 cm 3 |
Drain pump motor: Voltage | 220/ 240 V |
Spray arms, turning rhythm at alternating spray system: Final rinse | Spray arm lower ~ 2 min Spray arm upper ~ 2 min |
Detergent capacity: Dosage steps | 1 - 6 ml |
Coil of dispenser: Frequency | 50/60 Hz |
Regeneration: after wash cycles | Depending on the water hardness Wasserhärtebereich 0 - 60 (53) °dh 0 - 10,7 mmol/l 0 - 107 °fh |
Dimensions + Weight: Product dimensions (Weight) | 50 kg |
Options Power Zone: Delay function () | Multizone |
Flow rates/ Inlet volume: Spray arm upper | ~ 36 l/min - 50 l/min |
Reed contacts: Flow meter () | Salzanzeige |
Motor Diverter Valve: Frequency | 50/60 Hz |
Regeneration valve: Resistance | 3,13 k Ω |
Electronic boards: Serial boards () | siehe Boardaufdruck |
Data Energy Label: Energy Performance | A |
Flow rates/ Inlet volume: Flow meter | 208 lmp/l |
Data Energy Label: Reference program | A5h |
Размеры + Вес: Размеры продукта (ширина) | 59,7 cm |
Drain pump motor: Resistance | 146 Ω |
Succession of programs: Programs () | siehe Schließschema |
Motor pump heater: Safety thermostat self reset (Temperature of water) | 85 °C |
Электрические базовые данные: частота | 50 Hz |
Электрические базовые данные: Потребляемая мощность | 2,0 kW - 2,2 kW |
Spray arms, turning rhythm at alternating spray system: Prewash | Spray arm lower ~ 3 min Spray arm upper ~ 1 min |
Coil of dispenser: Voltage | 220/ 240 V |
NTC | 20 °C 58,1 kΩ 25 °C 47,1 kΩ 30 °C 38,2 kΩ 40 °C 25,4 kΩ 50 °C 17,2 kΩ 60 °C 11,8 kΩ 70 °C 8,3 kΩ 80 °C 6 kΩ 85 °C 4 kΩ |
Regeneration: Salt consumption for regeneration | ~ 77 g |
Dimensions + Weight: Wooden door (Height of plinth) | min. 93 mm |
Water softener setting Ω Ω Ω Ω Ω Ω: | (nach folgender Tabelle) |
Электрическая база данных: Предохранитель | 10 A |
Water pressure: Spray pump pressure | 0,2 bar - 0,4 bar |
Размеры + Вес: Размеры продукта (Глубина) | 57,0 cm |
Dimensions + Weight: Wooden door (Width) | 592 mm - 595 mm |
Spray arms, turning rhythm at alternating spray system: Service Test program | Spray arm lower ~ 30 s Spray arm upper ~ 30 s |
Regeneration valve: Voltage | 220/ 240 V |
Dimensions + Weight: Wooden door (Weight) | max. 5,5 kg |
Detergent capacity: Main wash | 40 cm 3 |
Motor pump heater: Voltage | 220 V - 230 V |
Spray arms, turning rhythm at alternating spray system: Main wash | Spray arm lower ~ 3 min Spray arm upper ~ 5 min |
Water softener: Regeneration dosage | 300 cm 3 |
Program information: Start indicator () | Alle Programme werden nach dem Programmstart verriegelt. Zum Ändern oder Beenden des gewählten Programms Startknopf länger als 1,5 s drücken. Bei Programmunterbrechungen läuft das Programm von der Stopposition an weiter. Ausnahme: Bei Programmunterbrechung in der Trocknungsphase wird das Programm beendet. |
Motor pump heater: Frequency | 50 Hz |
Single electric water inlet valve: Frequency | 50/60 Hz |
Dimensions + Weight: Wooden door (Thickness) | 16 mm - 20 mm |
Spray pump motor: Power Consumption | 30 W - 100 W |
Rotations: Spray arm lower | 25 UPM - 45 UPM |
Optical water indicator (OWI): Thermostat temp. sensor | (Werte siehe NTC) |
Data Energy Label: Cleaning Performance | A |
Flow rates/ Inlet volume: Drain pump | 16 l/min |
Размеры + Вес: Размеры продукта (Высота) | 82,0 cm - 87,0 cm |
Motor Diverter Valve: Resistance | 6,5 k Ω |
Regeneration: Number of cycles with 2 kg salt | ~ 26 |